READYMESH MM-150

15mm thin steel fibres

Kodi: RDM.0219

Përbërësit: 1

Pamja: Fibra

Fibres, obtained by the cutting of steel wire, with improved adhesion profile, for three-dimensional general structural reinforcement of cement-based conglomerates. The addition of READYMESH MM-150 significantly increases the mechanical performance of the structure in terms of toughness, ductility, fatigue, dynamic stress, shock, wear, tensile and shear strength and even post-cracking and damage behaviour. READYMESH MM-150 are particularly recommended for increasing ductility, toughness and thermal conductivity in concrete coatings for floor heating systems.

Kodi doganor

7326 2000

Linee di appartenenza

Vetitë themelore

Të përdoret me doreza mbrojtëse

Diametri: 0.75 mm

Jetëgjatësi e pakufizuar

Gjatësia: 15 mm

I pandezshëm

Veçoritë teknike

Lëndë jo helmuese

Rezistenca në tërheqje

>1100 MPa

Numri i filamenteve

~50000 nr/kg

Material alkalino-rezistent

Ngjyrat në dispozicion

- Çelik

Amballazhime dhe përmasa

- Koli: 50 x (Qese 20 kg)

- Qese 20 kg

Konsumi

Variable according to the type of work to be carried out and/or performance to be achieved.

Fushat e përdorimit

General preparation of screeds, cements and fibre-reinforced concrete. Particularly recommended for compact prefabrications, thin concrete floorings and radiant floor heating systems.

Mënyra e përdorimit

"READYMESH MM-150 fibres must be added to the concrete during mixing. It is recommended to pour the fibres directly onto the loading belt of the concrete mixer during the loading of the aggregates. Alternatively, it is possible to add them directly into the mixer after loading the concrete or into the onsite mixer. In this case, extend the mixing time by at least one minute (after a minimum of 3 minutes) for every m³ of packaged concrete in order to achieve optimal distribution. If using a 200-litre onsite mixer, add the fibres immediately after loading part of the aggregates and before adding the remaining parts. The typical dosage of READYMESH MM-150 fibres varies from 15 to 30kg/m³.

Conglomerates with READYMESH MM-150 can be easily transported and used with pumps, joiners, vibratory finishing machines, roadway extruders (e.g. slipform paver), etc. These fibres are typically used in conglomerates that have an aggregate diameter not exceeding 10-15mm."