Pamja: Pluhur + I lëngshëm
Osmotic fibre reinforced two-component cement mortar, based on hydraulic binders, modifying resins and flexibilisers, superpozzolanic reactive fillers, for the preparation of adhesive mixtures, easy to spread, which after hardening, provide an effective waterproofing protection, both in direct push and in negative pressure, with high capacity of deformation.
Llaçe për suva të brendshme dhe të jashtme – Llaç për çdo përdorim (GP)
Jetëgjatësia: 12 min
Përmasa maksimale e agregatit: 1 mm
Pot life: 50 - 70 min
Produkt në dukje
Rezistent ndaj rrezeve UV
Temperatura e aplikimit: +5 / +35 °C
Trashësia maksimale e lejueshme: 15 mm
Trashësia minimale e lejueshme: 5 mm
Lidhja e aderimit
Rezistenca nga ngjeshja
> 40 N/mm²
Rezistenca nga përkulja
> 8 N/mm²
- Qese 25 kg [A]
- Bidon 4.5 kg [B]
- Kit: 1 Qese 25 kg [A] + 1 Bidon 4.5 kg [B]
OSMOCEM RD synergistically brings together properties and benefits derived from the peculiar mix of components, which include superpozzolanic reactive fillers, for a net improvement of the chemical inertness and adherence, the reduction of porosity and permeability, with consequent reduction of carbonation. Suitable polymers present in the mixture also increase its deformability and stability, reducing scraps, detachments and cracks.
Approximately 18 kg/m² of OSMOCEM RD for every centimetre of thickness to be implemented (approximately 1800 kg per cubic metre).
Coatings, reconstructions and millimetric shields, finishing coats etc., in interventions to restore conservative, waterproofing works in reinforced concrete, wall coverings, extended exposed surfaces etc. provided they are sufficiently porous and absorbent and free from any waterproofing and / or water-repellent surface treatment, whether chemical (siloxanes, epoxies, polyurethanes, etc.) or natural (wax-up). Particularly indicated for interventions of dehumidification and anti-condensation rehabilitation of underground spaces, in combination with the dehumidifying cycle with CALEOSANA.
Application surfaces should be clean, free of soiling, crumbling and non-adhering parts, dust, etc., water repellent treatments in general, etc. conveniently saturated with water until they reach the condition "saturated with dry surface".
Mix the powder component (component A) with the hydrating solution (component B) with a drill at a low number of revolutions, pouring the powder progressively in the liquid, continue mixing until a homogeneous lump-free mixture is obtained. After mixing is completed wait a few minutes and stir again before proceeding with application.
To further improve the performance of the coating, insert a steel reinforcement mesh (wire 2 mm mesh and 5x5 cm) between layers.
- Makinë suvatimi
- Muratura të përziera
- Muratura me gurë
- Faqe shkëmbore
It is always essential to carry out preliminary tests to verify the appropriateness of the product, depending on specific requirements.
Do not apply in case of direct exposure to sunlight and cure the protection and moist hardening.
Do not apply on little or non-porous substrates or previously coated with water-repellent treatments in general, if not after appropriate roughening by bush hammers, sanders and equipment suitable for preparatory treatments of substrates, or after appropriate treatment with suitable polymeric primers.