Kodi: INT.0011
Përbërësit: 1
Pamja: Pluhur
A plaster for interiors and exteriors that is macroporous, in respect of green building standards, with high thermal insulation and anti-condensation performance, having a base of natural hydraulic lime NHL 3.5, siliceous aggregates, metakaolin, granular expanded silica with an extremely high volume of interconnecting voids and a low elastic modulus. Its particular characteristics make it suitable for dehumidification, for heat and humidity treatments on buildings and walls, in ecological building operations and in the restoration of historical buildings and monuments.
EN 998-1
Llaç për suva të brendshme dhe të jashtme – Llaç për rehabilitim (R)
Jetëgjatësia: 12 muaj
Përmasa maksimale e agregatit: 2 mm
Përzierja me ujë: 22 - 23 %
Pot life: 90 min
Lidhja e aderimit
0.40 N/mm²
Masa vëllimore
1075 kg/m³
Moduli elastik
< 5000 N/mm²
Përshkueshmëria e avullit të ujit
< 10 μ
Përthitha kapilare
0.83 kg•h^0.5/m²
Reagimi ndaj zjarrit
A1 _
Rezistenca nga ngjeshja
> 5 N/mm²
Rezistenca nga përkulja
> 2 N/mm²
Thermal conductivity
0.2 W/m*K
- Gri e hapur
- Qese 25 kg
CALEOSANA does not contains traces of resins, solvents or radioemissive aggregates.
Approximately 9 kg/m² of CALEOSANA for every centimetre of thickness to be implemented (approximately 900 kg per cubic metre).
Vintage and new construction masonries subject to rising damp, condensation, mildew. Recommended mainly for thermo-insulating anti-condensation rehabilitation of internal perimetral masonry and underground areas in general.
Removal of degraded plaster up to the ceiling. Cleaning the resulting supports, including the removal of salt deposits; thorough dedusting and saturation with water, to obtain the condition "saturated with dry surface".
In the presence of salt efflorescence brush thoroughly and spray the saline inhibitor SANAREG. If necessary, to increase plaster adhesion, apply a breathable anchoring scratch coat made with the specific lime-based preparation UNTERSANA. Prepare the plaster by adding CALEOSANA to the mixing water, continue to mix until the desired mixture and the complete elimination of lumps is obtained. Apply with float and trowel or plastering pump. It is recommended to apply a minimum thickness of cm 2.5. Regularisation of the plastered surfaces with SANASTOF lime-based ecological building fine mortar.
UNTERSANA rendering, applied by "spraying", must provide a rough, corrugated surface, designed to promote the bonding of the subsequent plaster, which must be applied no later than 2-3 days. For thicknesses greater than 2.5 cm, to improve the anti-cracking capacity, ensure the ARMAGLASS 160 mesh is inserted.
Protect fresh surfaces from direct exposure to the sun, the rain and the wind, cure the prolonged moist hardening.
- Mallë
- Mistri
- Makinë suvatimi
- Straight edge
- Ujë
- Beton
- Tulla
- Shtuf
- Muratura të përziera
- Muratura me tulla me vrimë
- Muratura me gurë
Vuoi saperne di più sui nostri prodotti?